Journal article 88 views 11 downloads

Pyrolysis-GCMS of Plastic and Paper Waste as Alternative Blast Furnace Reductants

Eurig Jones, Julian Steer Orcid Logo, FAWAZ OJOBOWALE, Richard Marsh, Peter Holliman Orcid Logo

ChemEngineering, Volume: 9, Issue: 1, Start page: 15

Swansea University Authors: Eurig Jones, FAWAZ OJOBOWALE, Peter Holliman Orcid Logo

  • 68788.VOR.pdf

    PDF | Version of Record

    © 2025 by the authors. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.

    Download (4.23MB)

Abstract

This paper reports studies on the thermal chemistry of the flash pyrolysis (heating rate of 20,000 °C/s up to 800 °C) of non-fossil fuel carbon (NFF-C) waste (or refuse-derived fuel, RDF) in the context of using this as an alternative reductant for blast furnace ironmaking. Gas chromatography–mass s...

Full description

Published in: ChemEngineering
ISSN: 2305-7084
Published: MDPI AG 2025
Online Access: Check full text

URI: https://cronfa.swan.ac.uk/Record/cronfa68788
Abstract: This paper reports studies on the thermal chemistry of the flash pyrolysis (heating rate of 20,000 °C/s up to 800 °C) of non-fossil fuel carbon (NFF-C) waste (or refuse-derived fuel, RDF) in the context of using this as an alternative reductant for blast furnace ironmaking. Gas chromatography–mass spectrometry (GCMS) analysis linked to the pyrolyser was used to simulate the thermal processes that take place during injection in the blast furnace raceway, where material experiences extreme temperature (ca. 1000 °C) over very short residence times (<300 ms). Species identification and qualitative analysis of evolved species generated are reported. Whilst the pyrolyser uses flash heating of a static sample, a drop tube furnace was also employed to study a sample moving rapidly through a pre-heated furnace held at 1000 °C to enable reductant burnout rates to be measured. The overarching aim of this piece of work is to study the suitability of replacing fossil fuel with non-recyclable plastic and paper as blast furnace reductants.
Keywords: pyrolysis; low carbon; reductants; fuel switching; refuse-derived fuel
College: Faculty of Science and Engineering
Funders: This work is supported by EPSRC’s Future steel Manufacturing research hub SUSTAIN programme EP/S018107/1 (E.W.J., P.J.H.), EPSRC SUSTAIN Research Hub—Feasibility Study SFSC1 002 (J.S.), EPSRC/Tata Steel iCASE (F.O.), HEFCW for funding capital grant for the pyrolysis-GCMS and STA and Welsh Govt Circular Economy Capital Fund (Grant # 243) for funding the bomb calorimeter.
Issue: 1
Start Page: 15