Journal article 615 views 148 downloads
The effects of surface finish on the fatigue performance of electron beam melted Ti–6Al–4V
,
A.A. Antonysamy,
F. Zelenka,
A. Scarpellini,
L. Parimi,
R. Maddalena,
Nick Barnard,
P. Efthymiadis
Materials Science and Engineering: A, Volume: 857, Start page: 144050
Swansea University Authors:
Lauren Ednie, Robert Lancaster , Nick Barnard
-
PDF | Version of Record
© 2022 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY license
Download (20.84MB)
DOI (Published version): 10.1016/j.msea.2022.144050
Abstract
Additive manufacturing (AM) is an advanced manufacturing technique whose uptake within the aerospace industry is being limited by the lack of understanding of the effects of surface finish on the fatigue properties of AM built components. It is known that the surface profile of as-built AM parts is...
| Published in: | Materials Science and Engineering: A |
|---|---|
| ISSN: | 0921-5093 |
| Published: |
Elsevier BV
2022
|
| Online Access: |
Check full text
|
| URI: | https://cronfa.swan.ac.uk/Record/cronfa61280 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Abstract: |
Additive manufacturing (AM) is an advanced manufacturing technique whose uptake within the aerospace industry is being limited by the lack of understanding of the effects of surface finish on the fatigue properties of AM built components. It is known that the surface profile of as-built AM parts is significantly rougher than its traditionally manufactured equivalent, promoting stress raising features that have an adverse effect on fatigue life. This paper will focus on developing a deeper understanding of the fatigue properties of the widely-used alpha-beta titanium alloy, Ti-6Al-4V, as manufactured through electron beam melting (EBM) and the role that surface roughness plays. Results have been generated on as-built and machined & polished EBM test coupons, supported by microstructural and fractographic analysis, X-ray computed tomography (XCT), advanced surface profilometry and hardness testing. Results have shown that as-built EBM Ti-6Al-4V samples have a significantly inferior fatigue life than machined & polished samples, despite the material in each of the surface finish types being hot isostatically pressed (HIP). It has been revealed that while surface parameters, MR2 and Ra, provide no correlation to high cycle fatigue life, it is shown that as the Rp surface parameter decreases, the respective number of cycles to failure increases. It can be concluded that a samples’ surface roughness is a highly contributing factor in influencing fatigue performance, yet it should not be considered in isolation since other features, including porosity, also play an important role. |
|---|---|
| Keywords: |
Electron Beam Melting; Ti-6Al-4V; Fatigue; Surface Roughness |
| College: |
Faculty of Science and Engineering |
| Funders: |
The current research was funded by the Materials and Manufacturing
Academy, M2A, (grant number: c80816) supported by the European
Social fund through the Welsh Government. The provision of a research
bursary, materials and supporting information from GKN Additive is
gratefully acknowledged. The assistance provided by the Swansea University AIM Facility and the Welsh Coating and Printing Centre, which
was funded in part by the EPSRC, are also much appreciated. |
| Start Page: |
144050 |