Journal article 1096 views 173 downloads
Effect of bending test on the performance of CdTe solar cells on flexible ultra-thin glass produced by MOCVD
,
Tom Dunlop ,
Stuart Irvine
Solar Energy Materials and Solar Cells, Volume: 211, Start page: 110552
Swansea University Authors:
Ana Teloeken, Dan Lamb , Tom Dunlop , Stuart Irvine
-
PDF | Version of Record
This is an open access article under the terms of a Creative Commons Attribution Non-Commercial No Derivatives License (CC-BY-NC-ND).
Download (1.24MB)
DOI (Published version): 10.1016/j.solmat.2020.110552
Abstract
The development of lightweight and flexible solar modules is highly desirable for high specific power applications, building integrated photovoltaics, unmanned aerial vehicles and space. Flexible metallic and polyimide foils are frequently used, but in this work an alternative substrate with attract...
| Published in: | Solar Energy Materials and Solar Cells |
|---|---|
| ISSN: | 0927-0248 |
| Published: |
Elsevier BV
2020
|
| Online Access: |
Check full text
|
| URI: | https://cronfa.swan.ac.uk/Record/cronfa53921 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Abstract: |
The development of lightweight and flexible solar modules is highly desirable for high specific power applications, building integrated photovoltaics, unmanned aerial vehicles and space. Flexible metallic and polyimide foils are frequently used, but in this work an alternative substrate with attractive properties, ultra-thin glass (UTG) has been employed. CdTe solar cells with average efficiency reaching 14.7% AM1.5G efficiency have been produced on UTG of 100 μm thickness. Little has been reported on the effects on PV performance when flexed, so we investigated the effects on J-V parameters when the measurements were performed in 40 mm and 32 mm bend radius, and in a planar state before and after the bend curvature was applied. The flat J-V measurements after 32 mm bending test showed some improvement in efficiency, Voc and FF, with values higher than the first measurement in a planar state. In addition, two CdTe solar cells with identical initial performance were subjected to 32 mm static bending test for 168 hours, the results showed excellent uniformity and stability and no significant variation on J-V parameters was observed. External quantum efficiency and capacitance voltage measurements were performed and showed no significant change in spectral response or carrier concentration. Residual stress analysis showed that no additional strain was induced within the film after the bending test and that the overall strain was low. This has demonstrated the feasibility of using CdTe solar cells on UTG in new applications, when a curved module is required without compromising performance. |
|---|---|
| Keywords: |
Metalorganic chemical vapor deposition; CdTe solar cells; Bending test; Thin films; Ultra-thin glass |
| College: |
Faculty of Science and Engineering |
| Start Page: |
110552 |